AGRICOW BRUSH - Installation and Assembly; Installazione E Montaggio

PENDULUM BRUSH
8
PENDULUM BRUSH
INSTALLAZIONE E MONTAGGIO
Assembly instructions:
The installation of THE Pendulum BRUSH consists of mounting it to the wall/girder using specific fastening systems,
followed by connection to the electrical system, which must be carried out by qualified personnel.
Optimal positioning and stable fastening are particularly important for the correct operation of the Agricow
pendulum brush. It is thus important to ensure that the mounting surface is stable and not exposed to vibrations
or movement.
Agricow advises against outdoor installation. Should this be necessary, it is mandatory to shelter
the box containing the electronic board and the box containing the sensor from rain or excessive
sunlight.
CAUTION:
The brush MUST be installed with the dedicated magnetothermal differential switch.
The procedures for installing the Pendulum brush are shown below.
The roller can be inserted in either direction.
The Pendulum brush is supplied with the machine body completely assembled and ready for installation,
excluding the assembly of the:
 •SUPPORTBRACKET,WHICHMUSTBEFASTENEDTOTHEWALLSOTHATTHEBRUSHSUPPORT
 CANBEHOOKEDTOIT(Fig.I,2,3,4)
 •ELECTRICALCABLE,TOBEFASTENEDINSIDETHECLIPSALREADYPOSITIONEDONTHEARM
SUPPORT (Fig. 5)
 •providetokeepatleast45cmor17,72”freebetweentheexistingcableandtherstclip
(fig.5).
INSTALLATION AND ASSEMBLY