AGS 900 - Master;Slave Wiring; Standard Capability Wiring; Full Systems Capability Wiring

pg 19
NOTE:
If the gates stop before they get to the
fully open or fully closed position, move
the violet wire from terminal 3 to terminal
1 on the master and move this same wire
from terminal 1 to terminal 3 on the slave.
NOTE:
1) The timer switch on the slave
circuit board must be OFF at
all times.
2) All peripheral devices must
be connected to the master
circuit board inputs.
Master/Slave Wiring
AGS 900 Standard Capability
9/1/96
AGS 900 Full Systems Capability
9/1/96