pg 18
Fine Tuning continued...
m If the gate seems to be functioning
in reverse, the right/left side operation
switch may need to be flipped (full system
capability only). One way to know if the
operator is working in reverse is to try the
sensitivity. If pressure is applied to the
gate while it is closing, it should reverse
and go open. If pressure is applied to the
gate while it is opening, it should stop and
remain stopped until activated again. If the
gate operator responds differently than
this, flip the right/left side operation switch.
If the auto close timer function is turned
on, this provides another way of knowing if
the operator is working in reverse. If when
the gate gets closed, the operator auto-
matically opens, the right/left side switch
may need to be flipped the other way.
m The receivers and transmitters
normally come from the factory with a
preset switch setting that is the same in all
units. It is recommended that this setting
be changed to reduce the possibility of
unauthorized access through the gate. To
change the switch setting, simply set the
switches in the radio receiver to any
arbitrary setting and then set the switches
in the transmitter/s to match the switches
in the receiver. When changing switches,
do not use a pen or pencil because these
may cause debris to fall into the switches.
Use a paper clip or other device that will
not deposit debris. The battery in the
transmitter may last 1 to 2 years. Be sure
to replace the battery only with one that is
the same type as the original.
FULL SYSTEMS CAPABILITY
To Next Page
Loading...