• Interconnections
+
+
+
+
+
+
The effects processor can be used effects processor before the power
as a table top unit. The unit should is turned ON.
be situated so that its location or
To avoid signal overloading,
position does not get affected by
distortion and to minimize the
the heat of the amplifier.
noise, it is necessary to set the
The effects processor must always proper signal levels at every point
be powered through a 9V AC in the send / return chain.
adaptor supplied alongwith.
The connection diagrams that
Always insert the AC adaptor plug follow display the typical types of
into the 9V AC power socket of the input sources and output
unit and then connect the AC equipments which can be
adaptor to an AC mains outlet. connected to the effects processor.
For correct connections and
When foot switch is to be used,
operation, check the specification
always connect the foot switch to
of the connected equipment.
the bypass jack socket of the
7
9V AC Adaptor Foot Switch
MX-15
MX-15
Preamp
Output
Mic-1
Send
Mic-1
Return
PSX-1200
SSA-250M
BTZ-7000
SSA-250M
BTZ-7000
ZONE-A ZONE-A
Line Input
Aux Input
9 VAC~
POWER
BYPASS OUTPUT INPUT
LEFT LEFT (MONO)
RIGHT RIGHT
DFX-16 (Rear Panel)
Mixing Console
P r o
S e r i e s
A M X - 1 6 1 2
Aux Return
Aux Send (Post Fade)
To Next Page
Loading...