Need help?Do you have a question about the Ahuja SSA-160 EM and is the answer not in the manual?
General| Power Output | 160 Watts |
|---|---|
| Frequency Response | 50Hz-15kHz ±3dB |
| Total Harmonic Distortion | Less than 0.5% at 1KHz |
| Speaker Impedance | 4Ω |
| Inputs | 2 × Mic 1 × Aux |
| Outputs | Line Output |
| Tone Controls | Bass, Treble |
| Power Supply | AC: 220-240V 50/60Hz |
| Input Impedance | 470kΩ for Aux |
To reduce risk of electric shock, do not remove top cover. Refer servicing to qualified personnel. Replace fuses with same specification.
Precautions regarding water, power source, cord protection, generator operation, ventilation, stability, cover strip, earthing, cleaning, and heat exposure.
Guidelines for connecting box-type speakers to COM-4Ω/8Ω terminals, including switch settings.
Instructions for connecting a SAX-300DX speaker to the amplifier's COM & 8 ohm terminals.
Wiring two SRX-120DX speakers in parallel for a 4 ohm system connection.
Wiring two SAX-150DX speakers in parallel for a 4 ohm system connection.
Connecting Driver Units/Horn/Column speakers with 100V LMT to COM-70V/100V terminals.
Operation of 16 Driver Units with 100V LMT connected at 10 Watts tap.
Guidelines for connecting combinations of driver units, column, wall, and ceiling speakers with 100V LMT.
Explanation of 70V line usage for even sound distribution with multiple speakers/driver units.
Ensuring proper sound distribution by correct phasing of speakers/units facing the same direction.
Setup for a 410W mono system using SSA-160EM and one BR-250M booster amplifier.
Setup for a 660W mono system using SSA-160EM and one SPA-5000EM booster amplifier.
Configuration for a 1160W mono system using SSA-160EM and four BR-250M booster amplifiers.
To Next Page
