Reset the house code
Sometimes in order to resolve an RF communication issue, e.g. Alarms have to be relocated, it may be
necessary to reset and house code all RadioLINK Alarms and devices in the system again.
To reset the Alarm Controller press and hold the house code button.
All segments will flash blue briefly and then go solid. After 5 seconds
approx. the segments will start flashing blue. At this point release
the house code button. The Alarm Controller has now been reset.
To reset the other RadioLINK Alarms and devices in the system
consult the appropriate instruction manuals.
Fire / CO Alarm Controller
MODE
POWERH.CODE
OFFON
12
To Next Page
