9. System Diagnostics
The system diagnostic mode does not work with all RadioLINK alarms and accessories. If the system
diagnostic features are required for your installation please contact technical support to verify that
all your RadioLINK components are compatible with these features.
The System Diagnostic features are intended to assist professional installation and maintenance
personal to install, commission and maintain the RadioLINK Fire and CO systems utilising the Alarm
Controller.
These features are not intended for the home owner / tenant and should only be used by personnel
described above.
A special system diagnostic mode will facilitate the following special
tests.
1. Two minute “Long Test”. This is an alternative to the walk round test
described previously.
2. The check alarm memory test will identify an Alarm that had been
previously activated.
To Next Page
