Aicon PRO DAC4503 - Aicon Stapler Adjustments; Nailing Depth Control; Exhaust & No-Mar Tip Attachment

DAC4503
27
COLD WEATHER OPERATION
WARNING
DO NOT USE A FROZEN TOOL. Allow tool to thaw before
using. Moisture frozen in the tool may impede internal
components resulting in the risk of injury and/or tool
damage.
When using the tool in cold conditions the tool will cycle
slower than usual while driving the first nails. The cycle rate
will increase as the tool warms up. Keep tool warm to avoid
reduced cycle rate.
ADJUSTING THE NAILING DEPTH
WARNING
Disconnect the tool from the air source before making
adjustments. Such precautionary safety measures reduce
the risk or unintentional tool operation.
1. Disconnect tool from air supply.
2. Remove nails from the tool.
3. Adjust tool driving depth:
 To reduce the nail depth, turn the adjustment knob
Counter clockwise (FIG8).
 To drive the nail deeper, turn the adjustment knob
clockwise (FIG 9).
4. Reload nails as described in the "Loading Nails" section
of this manual.
5. Reconnect air supply.
FIG. 8
FIG. 9
ADJUSTING THE EXHAUST
The direction of the exhaust vent can be changed by turning
the top cover (FIG 10).
FIG. 10
USING THE NO-MAR TIP
WARNING
When attaching or detaching the No-Mar Tip, be sure to
remove your finger from the trigger and disconnect the air
house from the nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the safety, attach the
accessory No-Mar Tip to the safety.
TO REPLACE THE NO-MAR TIP:
1) Disconnect air hose from tool.
2) Put the No-Mar Tip to the toe of the safety.
To remove the No-Mar Tip: Pull the no mar tip directly away
from tool.
FIG. 11
NOTE:
The nose cap may reduce nailing depth due to its thickness.
Re-adjustment of nailing depth is required.
To Shallow
Flush
Turn the adjustment knob counter clockwise
Safety
No-Mar Tip
To Deep
Flush
Turn the adjustment knob counter clockwise