Aim-TTI PSA3605 - Power Requirements; Mechanical, Environmental and Safety

Page 76
USB Flash Drive
interface:
USB standard A connector (USB Host) for connection of USB Flash
memory drive
Audio Connector:
3.5 mm jack socket for demodulated audio out (mono/stereo plugs).
Trigger connector:
3.5mm mono jack socket for connection of BNC adaptor (supplied).
Display
Display Type:
4.3 inch (10.9 cm) transflective backlit TFT LCD, 480 x 272 pixels
total, 16 colours, resistive touch screen.
Graticule:
8.5 x 10 divisions light grey graticule. Selectable as normal, dim,
levels only, or off.
13.1.7 Power Requirements
Battery Operation
The PSAxx05 operates from internal rechargeable batteries. The
batteries are recharged using the AC power adaptor supplied.
Battery Type:
Li-ion 3.7V, 3Ahr nominal
Battery Life:
> 3 hours continuous operation
Recharge Time:
< 3 hours from fully discharged
Auto-Sleep Mode:
To conserve battery life, the system can be set to automatically switch
into sleep mode after a defined time from the last key press. This can
be set between 5 mins and 60 mins (or never).
AC Line Operation
The PSAxx05 can be operated continuously from mains power using
the AC power adaptor provided by Aim-TTi. This also recharges the
internal battery.
Input Voltage
Range:
100V to 240V nominal 50Hz/60Hz. Interchangeable plus for UK, Euro,
USA and Australia are supplied.
13.1.8 Mechanical, Environmental and Safety
Mechanical
Size:
192 x 92 x 49mm (7.5 x 3.6 x 1.9”) plus 12mm projection of N-Type
signal connector
Weight:
560 grms (1lb 4oz).
Tilt Stand:
Built-in tilt stand for bench use which angles the unit at approximately
40 degrees to the horizontal.
Screen Protector
For portable use, the tilt stand can be moved from the rear of the
instrument to the front where it acts as a screen protector/sun shield.
Environmental and Safety
Operating Range:
+5
o
C to + 40
o
C, 20% to 80% RH.
Storage Range:
-10
o
C to +50
o
C
Environmental:
Indoor use at altitudes to 2000m, Pollution Degree 2.
Safety & EMC:
Complies with EN60950-1 & EN61326-1.
For details, request the EU Declaration of Conformity for this
instrument via
http://www.aimtti.com/support (serial no. needed).