ALWAYS check your local laws and regulations to determine if it
is lawful to ride Class 3 eBikes on public roads before
increasing your
bicycle’s top speed. Laws vary by territory,
state, trail, path, and road so you will need to check the
applicable regulations in each new
location you ride.
Class 3 Label
If you increase your bicycle’s top speed, you must rem ove the
Class 2 label that displays your Aipas eBike class, top pedal
assisted speed, and motor wattage. This label is posted under the
carry handle, near the seat tube on the bicycle.
Ride within your limits to prevent serious injury or death.
Riding at higher speeds poses an increased safety risk.
ALWAYS wear a helmet and obey the rules of the road.
Use increased caution when riding at speeds above 20mph
when the bike is carrying cargo, as this riding condition will
impact stopping
time, turning, and balance. These conditions
carry an increased risk
of serious injury or death.
To increase maximum speed:
1. Press and hold the plus (+) and minus (-) buttons on the
control pad simultaneously until the screen says “P1” .
2. Press the
button on the control pad to cycle through
the settings.
3. Go to setting “P08” and change this value from 32 to 100.
NOTE: This setting represents the top speed in kilometers
per hour. For Class 2 performance, this speed setting
must not exceed 20 mph (32 km/h). For Class 3
performance, this setting will be set at 100, indicating
the bike has been completely
unlocked to enable speeds
of up to 28mph. Please note: The
maximum achievable
conditions, total payload, battery charge level and other
factors.
top speed will vary by tire inflation pressure, road
WARNING!
WARNING!
To Next Page
Loading...