Aiphone JM-4MED - Mounting Procedure

14
Mounting procedure
■
JM-4MED
<Back wiring>
Mounting bracket
(pre-attached by factory)
3-gang box
The unit
Mounting screw × 4 (included)
Wires
CAT5e cable
83.5mm (3-5/16")
Connect the CAT5e cable and wires to the unit.
2
Mount the unit on the
3
mounting bracket.
How to connect or disconnect wires
Insert the
•
wire into one of the coupling terminals.
To ensure that the wire will not bend, press the
•
release button while inserting into terminal.
Opening/closing the terminal cover
To open:
Slide the cover to the right until it clicks, and then open.
To close:
Close the cover, and then slide it to the left until it clicks.
Make sure the cover is locked.
*
Release
button
8mm
(3/8")
Terminal cover
Close
Open
Fasten the mounting
1
bracket to the wall.