Air Hogs Zero Gravity Nano Wall Climber - Driving Modes and Trim Adjustment; Driving on Walls or Upside Down; Driving on the Ground; Trim Adjustment

TRIM ADJUSTMENT
A
B
DRIVINGONWALLSORUPSIDE DOWN
To drive on walls and upside down you must have switch positioned
to the left (under “W”. )
To drive on ground you must have the switch positioned in the
middle (under “
G ”.)
NOTE: Avoid driving overhead when other people are
around. Do not stand underneath when driving overhead.
DRIVINGONTHEGROUND
The fan will not turn ON,buttheheadlightswillturnonand
the vehicle will drive full function on the ground. (The ground
mode saves the battery charge).
Place the
v
ehicl
e
in
gro
und mo
d
e
and dr
i
ve
fo
r
ward using the
buttons on the Left hand side of the controller.
If the vehicle turns to the LEFT, p re s s t h e R igh t t r i m b u t t on
until it drives straight (A).
If the vehicle turns to the RIGHT, press the Left trim button
until it drives straight (B).
The fabric air skirts can be adjusted outward at a 45°angle
to ensure a proper wall suction.
IMPORTANT: The Zero Gravity Nano™shouldonlybe
driven on a smooth, clean, flat surface. Dirt or debris can
get inside the fan and cause damage.
When finished playing with your Zero Gravity Nano™, remove vehicle from wall Turn vehicle OFF,
and Turn the controller OFF. NOTE: The trim setting will reset when the vehicle and controller are turned off.
OFF
OFF
B
F
R
L
R
R
L
R
R
L
L
R
OFF
3