Air King RF55 User Manual

READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock and injury to person, including the following:
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK
AND INJURY TO PERSON, OBSERVE THE FOLLOWING:
1. Read all instructions before installing or using range hood.
2. Use this unit only in the manner intended by the manufacturer. If
you have questions, contact the manufacturer.
3. Before servicing or cleaning the unit, switch power off at service
panel and lock the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
4. Installation work and electrical wiring must be done by qualified
person(s) in accordance with all applicable codes and standards,
including fire-related construction.
5. Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment manufacturer’s
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA) and the American
Society for Heating, Refrigeration, and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
CAUTION: FOR GENERAL VENTILATING USE ONLY. DO NOT USE
TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS AND VAPORS.
6. When cutting or drilling into wall or ceiling, do not damage electrical
wiring and other hidden utilities.
CAUTION: TO REDUCE THE RISK OF FIRE AND TO PROPERLY
EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE - DO NOT VENT
EXHAUST AIR INTO SPACES WITHIN WALLS OR CEILINGS OR INTO
ATTICS, CRAWL SPACES, OR GARAGES.
7. This unit must be grounded.
8. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power unit.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, DO
NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE.
WARNING: TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
a) Never leave surface units unattended at high settings. Boilovers
cause smoking and greasy spillovers that may ignite. Heat oils
slowly on low or medium settings.
b) Always turn hood ON when cooking at high heat or when
flambéing food (ie. Crepes Suzette, Cherries Jubilee, Peppercorn
Beef Flambé).
c) Clean ventilating fans frequently. Grease should not be allowed
to accumulate on fan filter.
d) Use proper pan size. Always use cookware appropriate for the
size of the surface element.
WARNING: TO REDUCE THE RISK OF INJURY TO PERSONS IN
THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
a) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off burner. BE CAREFUL TO PREVENT
BURNS. If the flames do not go out immediately, EVACUATE
AND CALL THE FIRE DEPARTMENT.
b) NEVER PICK UP A FLAMING PAN - You may be burned.
c) DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result.
d) Use an extinguisher ONLY if:
I. You know you have a Class ABC extinguisher, and you already
know how to operate it.
II. The fire is small and contained in the area where it started.
III. The fire department is being called.
IV. You can fight the fire with your back to an exit.
WARNING: TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCTWORK.
www.airkinglimited.com
6728001 Rev. B 3-07
1
AD Series Range Hood
IMPORTANT INSTRUCTIONS -
OPERATING MANUAL

Air King RF55 Specifications

General

Brand	Air King
Model	RF55
Category	Ventilation Hood
Language	English

Summary

Important Instructions and Safety Information

General Safety Information

Basic precautions for using electrical appliances to reduce fire, shock, and injury risks.

Risk Reduction: Fire, Electric Shock, Injury

Specific warnings to reduce the risk of fire, electric shock, and personal injury during operation.

Ventilation Use Limitation

Cautionary note for general ventilating use only, not for hazardous or explosive materials.

Proper Air Exhaustion

Caution to properly exhaust air outside, not into internal spaces like attics or garages.

Range Top Grease Fire Prevention

Warnings detailing how to prevent range top grease fires.

Grease Fire Injury Prevention

Instructions to minimize injury risk during a range top grease fire.

Ductwork Fire Risk

Warning to use only metal ductwork to reduce the risk of fire.

Installation Instructions

Hood Support Location Preparation

Steps for preparing the mounting location, especially under cabinets, using wood strips.

Hood Preparation for Mounting

Instructions for preparing the hood itself, including lamp installation and electrical knockout.

Mounting the Range Hood

Detailed steps for physically attaching the range hood to the wall or cabinet.

Electrical Wiring Connections

Guidance on making safe and compliant electrical connections for the range hood.

Operation and Maintenance

Operation Controls Overview

Explanation of the rocker switches for controlling the light and exhaust fan speeds.

Maintenance Precautions

Important safety notes and procedures before performing any maintenance or cleaning.

Filter Information

Details regarding the combination grease/charcoal filter, including replacement.

Cleaning Procedures

Safe and effective methods for cleaning the range hood without damage.

Troubleshooting Common Issues

A guide to diagnosing and resolving common operational problems with the range hood.

Limited Warranty and Support

Product Warranty Details

Information on the warranty period, coverage, and exclusions for Air King products.

Technical Assistance and Parts

Contact information and procedures for obtaining parts or technical support.

Replacement Parts Diagram