AirLive SP-101 - Firmware update over the air (OTA); Troubleshooting

1. Overview
AirLive SP-101 User Manual
10
1.5.5. Firmware update over the air (OTA)
Plug is based on 500 series SoC and supports Firmware Update Command Class, it can
receives the updated firmware image sent by controller via the Z-wave RF media. It is a
helpful and convenient way to improve some function if needed.
1.5.6. Command Classes
The Switch supports Command Classes including…
* COMMAND_CLASS_ZWAVEPLUS_INFO
* COMMAND_CLASS_VERSION
* COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2
* COMMAND_CLASS_SECURITY
* COMMAND_CLASS_DEVICE_RESET_LOCALLY
* COMMAND_CLASS_ASSOCIATION_V2
* COMMAND_CLASS_ASSOCIATION_GRP_INFO
* COMMAND_CLASS_POWERLEVEL
* COMMAND_CLASS_SWITCH_BINARY
* COMMAND_CLASS_BASIC
* COMMAND_CLASS_SWITCH_ALL
* COMMAND_CLASS_METER_V3
* COMMAND_CLASS_CONFIGURATION
* COMMAND_CLASS_ALARM
* COMMAND_CLASS_PROTECTION
* COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2
1.6 Troubleshooting
Symptom
Cause of Failure
Recommendation
The Switch not working and
LED off
1. The Switch is not plugged
into the electrical outlet
properly
2. The Switch break down
1. Check power connections
2. Don’t open up the Switch
and send it for repair.
The Switch LED
illuminating, but cannot
control the ON/OFF Switch
of the load attached
1. Check if the load
plugged into the Switch
has its own ON/OFF
switch
2. The switch is protected
1. Set the ON/OFF switch of
the load attached to ON
2. Unprotected the switch or
follow the instruction of
protection.
The Switch LED
illuminating, but the
Detector cannot control the
Switch
Not carry out association
Same frequency
interference
1. Carry out association
2. Wait for a while to re-try
LED keep flashing, but
cannot control
Overload occurs
Remove the load attached
or check max.
load cannot exceed 12A
(Resistive load)