This plug-in ON/OFF switch is a security enabled wireless switch, based on Z-Wave Plus
technology. Z-Wave PlusTM enabled devices displaying the Z-Wave PlusTM logo can also
be used with it regardless of the manufacturer, and can also be used in other
manufacturer’s Z-WaveTM enabled networks. Remote On/Off control of the connected load
is possible with other manufacturer’s wireless Controller. Each switch is designed to act as
a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by
its intended destination by routing the signal around obstacles and radio dead spots.
Because plug supports Security Command Class, it can learn with Secured controller. Its
functionality and supported command classes is identical when included as a secure and
non-secure device.
This plug-in ON/OFF switch is able to detect instance wattage (3000W/230Vac) (13Ampere)
and overload current (14.5A with resistive load) of connected lights or appliances. When
detecting overload state, the Switch will be disabled and its On/Off button will be lockout of
which LED will flash quickly. However, unplug and reconnect the switch will reset its
overload condition to normal status.
1.1 Adding to Z-WaveTM Network
In the front casing, there is an On/Off button with LED indicator which is used to toggle
switch on and off or carry out inclusion, exclusion, reset or association. When first power is
applied, its LED flashes on and off alternately and repeatedly at 0.5 second intervals. It
implies that it has not been assigned a node ID and start auto inclusion.
To Next Page
Loading...
