AirLive SP-101 - Auto Inclusion

1. Overview
AirLive SP-101 User Manual
2
1.1.1. Auto Inclusion
The function of auto inclusion will be executed as long as the switch does not have Node ID
and just plug the switch into a wall outlet.
Note: Auto inclusion timeout is 2 minute during which the node information of explorer
frame will be emitted once several seconds. Unlike “inclusion” function as shown in the
table below, the execution of auto inclusion is free from pressing the On/Off button on the
Switch.
The table below lists an operation summary of basic Z-Wave functions. Please refer to the
instructions for your Z-WaveTM Certificated Primary Controller to access the Setup function,
and to include/exclude/associate devices.
Function
Description
Annotation
No node ID
The Z-Wave Controller does not
allocate a node ID to the Switch.
LED 2-second on, 2-second off
Inclusion
1. Put your Z-Wave controller into
in
clusion mode by following the
instructions provided by the controller
manufacturer.
2. Pressing On/Off button three times
within 2 seconds will enter inclusion
mode.
Exclusion
1. Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the controller
manufacturer.
2. Pressing On/Off button three
times within 2 seconds will enter
exclusion mode.
Node ID has been excluded.
LED 0.5s On, 0.5s Off (Enter auto
inclusion)
Reset
1.
Pressing On/Off button three times
withi
n 2 seconds will enter inclusion
mode.
Use this procedure only in the
event that the primary controller
is lost or otherwise inoperable.
2.
Within 1 second, press On/Off
button again for 5 seconds.
3.
IDs are excluded.
LED 0.5s On, 0.5s Off (Enter auto
inclusion)
Association
1. The Plug is an always listening
Z-
Wave device, so associations may
be added or removed by a controller
at any time.