1.> Connect your internet cable to WAN port of WL-5470PoE and connect your PC to
LAN 2 via Ethernet cable .
2.> Connect the power adapter to the WL-5470PoE ’s power port.
3.> Wait about 1 ~ 2 minutes to complete the bootup procedure .
4.> Please make sure your PC’s IP is in the same subnet as the AP
(e.g 192.168.100.100 Subnet mask : 255.255.255.0) .
5.>Check whether you can ping WL-5470PoE’s IP (192.168.100.252).
If you can not ping 192.168.100.252 , please try the tips as below.
Please try to open the cmd window and input command: arp –d .
The command will clean the arp table.
Please input the command “arp –d” several times until it shows “the specified entry
was not found”, and try again.
To Next Page
Need help?
General
