Need help?Do you have a question about the AirLive WL-5470POE and is the answer not in the manual?
Guides users through the initial setup and installation process of the WL-5470POE.
Describes the function and setup of the Access Point mode.
Explains how to configure and use the device in Client (Infrastructure) mode.
Details the Bridge mode, useful for extending wireless networks.
Explains the WDS Repeater mode for wireless network extension.
Describes the Universal Repeater mode for extending wireless coverage.
Details the WISP mode, allowing sharing of WISP connections.
Guides through configuring the WISP + Universal Repeater mode.
Explains how to set up the Gateway (AP + Router) mode.
Configures the device when operating in Access Point mode.
Details the settings for configuring the device in Client mode.
Provides configuration options for the Bridge mode operation.
Explains how to configure the WDS Repeater mode for network extension.
Covers configuration for the Universal Repeater mode.
Details the configuration options for the WISP mode.
Covers configuring wireless security settings like WEP, WPA, WPA2.
Provides steps to recover the device after a firmware crash.
Guides users through the initial setup and installation process of the WL-5470POE.
Describes the function and setup of the Access Point mode.
Explains how to configure and use the device in Client (Infrastructure) mode.
Details the Bridge mode, useful for extending wireless networks.
Explains the WDS Repeater mode for wireless network extension.
Describes the Universal Repeater mode for extending wireless coverage.
Details the WISP mode, allowing sharing of WISP connections.
Guides through configuring the WISP + Universal Repeater mode.
Explains how to set up the Gateway (AP + Router) mode.
Configures the device when operating in Access Point mode.
Details the settings for configuring the device in Client mode.
Provides configuration options for the Bridge mode operation.
Explains how to configure the WDS Repeater mode for network extension.
Covers configuration for the Universal Repeater mode.
Details the configuration options for the WISP mode.
Covers configuring wireless security settings like WEP, WPA, WPA2.
Provides steps to recover the device after a firmware crash.
General| Wireless Standards | IEEE 802.11b/g |
|---|---|
| Frequency Band | 2.4 GHz |
| Data Rate | Up to 54 Mbps |
| Antenna Gain | 2 dBi |
| Storage Temperature | -20°C to 70°C |
| Ports | 1 x 10/100Mbps RJ-45 |
| Power Supply | PoE (Power over Ethernet) |
| Operating Modes | Access Point, Client, Repeater, WDS |
| Security | WEP, WPA, WPA2 |
| Operating Temperature | 0°C to 40°C |
| Humidity | 10% to 90% (Non-condensing) |
To Next Page
