AirLive G.DUO - User Manual

G.DUO
Dual 11g Access Point
Use
r
’s Manual

Summary

Installing the G.DUO

2.1 Before You Start

2.4 Hardware Installation

Guides through the physical installation steps, including antenna, power, and PC connection.

Configuring the G.DUO

3.1 Important Information

3.3 Management Interface

Explains various interfaces for configuring the G.DUO, including web and command line.

3.5 Initial Configurations

Recommends initial configuration steps for first-time users of the G.DUO.

3.5.1 Choose the wireless Operation Modes

3.5.2 Change the Device’s IP Address

Details how to change the G.DUO's IP address and configure gateway/DNS settings.

3.5.3 Enable Password Protection

Explains how to enable password protection and set a username/password for the G.DUO.

3.5.4 Enable Telnet or SSH

WISP + AP Mode

4.1 Application for WISP+AP Mode

Describes the WISP+AP mode, designed for WISP subscribers to share internet access.

4.3 Radio1: WISP Router Mode Settings

Explains Radio1 settings in Client Mode with NAT routing for WISP connections.

4.3.2 Security Settings

Details security settings for WEP and WPA/WPA2 encryption.

4.3.3 Advance (Wireless Settings)

4.4 Radio2: AP Mode Settings

Configures Radio2 to operate in Access Point mode with its default SSID.

Dual AP Mode

5.1 Application for Dual AP Mode

Explains Dual AP mode for extending hotspot network coverage.

5.2 Radio1 and 2: AP Mode Settings

Details AP mode settings for both Radio1 and Radio2.

5.2.2 Security Settings

Details security settings for WEP and WPA/WPA2 encryption in Dual AP mode.

5.2.3 Advance (Wireless Settings)

Client + AP Mode

6.1 Application for Client + AP Mode

Explains Client+AP mode for use as a wireless repeater to extend router signal.

6.2 Radio1: Client Mode Settings

Configures Radio1 in Client mode to connect to a remote AP.

6.2.2 Security Settings

6.2.3 Advance (Wireless Settings)

Gateway + AP Mode

7.1 Application for Gateway +AP Mode

7.2 Radio1: WISP Router Mode Settings

Configures Radio1 as a wireless router with WAN settings for Gateway+AP mode.

7.2.2 Security Settings

7.2.3 Advance (Wireless Settings)

7.3 Radio2: AP Mode Settings

WDS + AP Mode

8.1 Application for WDS + AP Mode

8.2 Radio1: WDS Bridge Settings

Configures Radio1 in WDS Bridge mode to connect to a remote bridge network.

8.2.2 WDS Security

8.2.3 Advance (Wireless Settings)

8.3 Radio2: AP Mode Settings

System Configuration Menu

9.2 LAN Interface Setup

Covers configuration of the LAN interface, including IP address and DHCP settings.

9.3 Time Settings

9.4 Password Settings

Enables password protection and changes the username/password.

9.5 System Management

9.7 Watchdog

9.7.2 Configuration Save and Restore

Emergency Firmware Recovery

How Emergency Upgrade Works?

Procedure to Restore the AP using Emergency Upgrade

AirLive G.DUO Specifications

General

Frequency Band	2.4 GHz
Power Supply	12V DC, 1A
Wireless Standards	IEEE 802.11b/g/n
Antenna	2 x 5 dBi detachable omnidirectional
Ethernet Ports	1 x 10/100 Mbps
Operating Modes	Access Point, Client, WDS, Repeater
Security	WEP, WPA, WPA2