3
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the
carton), must be fitted to the unit. These are to be
attached to the base of the heater using the 4 self-tapping
screws provided, taking care to ensure that they are located
correctly in the bottom ends of the heater side moldings
NOTE: It is normal when the heaters are turned on for the first time or when they
are turned on after having not been used for a long period of time the heaters may
emit some smell and fumes. This will disappear when the heater has been on a short
while.
Control Panel
To Next Page
Loading...