5
PROTECTION AGAINST OVERHEATING
1) An additional fitted safety thermostat protects the heater against overheating and
switches it off automatically. The service lamp then goes out. The heater is ready
for service again after a short cooling-off phase (approx. 15 minutes).
2) If this repeat itself, first check whether the thermostat switch it set correctly or i
f
objects hinder the heating operation.
Always un-plug the heater from the wall socket and allow it to cool down before
cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
When the heater is not used for long periods of time it should be protected from dust
and stored in a clean dry place.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.
To Next Page
Loading...