EasyManua.ls Logo

Airofog AE9 - If EC Does Not Function Correctly

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26 AE: V2016-03
Check first:
- Fogger runs correctly so there is sufficient air
pressure to open EC.
Possible causes: Check:
18. EC funktioniert nicht ordnungsgemäß:
Vorabkontrollen:
- Nebelgerät läuft ordnungsgemäß, der
Luftdruck reicht also zum Öffnen der EC aus.
- Nebelgerät stoppt,
Bedienhebel wird
nicht automatisch
ausgerückt
Mögliche Ursachen: Folgende Punkte kontrollieren:
- Schraubenartiger Nippel
(EC25) am Bowdenzug
(EC23) falsch eingestellt
- Kolbenstift (EC8) kehrt nicht
in seine Ausgangsposition
zurück
- Feder (EC9) zu schwach
oder gebrochen
- Membran (EC6) der
Druckmessdose beschädigt
oder verunreinigt
- Nebelgerät in
Betrieb und Hebel
wird ausgerückt,
Vernebelung stoppt
nicht
- Schraubenartiger Nippel
(EC25) am Bowdenzug
(EC23) falsch eingestellt
- Kolbenstift (EC8) wurde
nicht gedrückt
- Feder (EC9) zu stark
- Membran (EC6) der
Druckmessdose beschädigt
oder verunreinigt
- Druckabfall im EC-System
- Luftdruckleitung (EC20)
verstopft
- Schraubenartiger Nippel
(EC25) am Bowdenzug
(EC23) falsch eingestellt
- Feder (EC28) zu schwach
oder gebrochen
- O-Ring (EC32) beschädigt
- Ventilgehäuse (EC33)
verunreinigt
- fogger stops,
operating lever does
not release
automatically
- incorrect setting of screw
type nipple (EC25) at the
Bowden cable (EC23)
- piston (EC8) is not pushed
back into initial position.
- spring (EC9) too weak
or broken
- the diaphragm (EC6) of
the pressure cell is
damaged or dirty
- incorrect setting of screw
type nipple (EC25) at the
Bowden cable (EC23)
- piston (EC8) is not pushed
forward
- spring (EC9) too strong
- the diaphragm (EC6) of
the pressure cell is
damaged or dirty
- leak of pressure in the
“EC” system
- clog of air pressure
tube (EC20)
- incorrect setting of screw
type nipple (EC25) at the
Bowden cable (EC23)
- spring (EC28) too weak
or broken
- damage of o-ring (EC32)
- valve housing (EC33)
dirty
- fogger engine runs
but lever can
not engage
- fogger in operation
and lever releases,
fog does not stop
- Motor des
Nebelgeräts läuft,
aber Hebel kann
nicht eingerückt
werden
18. If EC does not function correctly:

Related product manuals