Why does my Airrex HWC-19P Air Conditioner generate white vapor during operation?
If you observe white vapor being generated during operation of your Airrex Air Conditioner, it might be due to high humidity in the environment. When humidity is high, the unit discharges a lot of air, which can cause white vapor to be emitted.
How to improve cooling on my Airrex Air Conditioner?
If your Airrex Air Conditioner isn't cooling well, try the following: * Clean the filter by washing it with water. * Clean the heat exchanger. * Ensure there are no obstacles blocking airflow, maintaining a distance greater than 8 inches. * Adjust the set temperature to be lower than the ambient temperature for cooling. * Confirm that the water supply valve is open. * Check that the compressor operates normally and discharges cold air after 3 minutes.
What to do if my Airrex HWC-19P is not turning on?
If your Airrex Air Conditioner is not operating, please check the following: * Ensure the plug is properly inserted. * Press the ON/OFF switch and check the lamp condition. * Replace the fuse in the electrical panel if needed. * Check the load capacity and raise the circuit breaker of the distribution panel if necessary. * Ensure the unit is being used in an environment of 113°F or lower. * Consult an electrician to ensure the rated voltage is appropriate.
Why is dew forming at the discharging hole of my Airrex Air Conditioner?
The formation of dew at the discharging hole of your Airrex Air Conditioner is a normal phenomenon. It occurs when moisture in the air condenses into dew, especially if the room temperature is high. This is not an indication of a malfunction.
General| Brand | Airrex |
|---|---|
| Model | HWC-19P |
| Category | Air Conditioner |
| Language | English |
Summarizes critical safety warnings and cautions to prevent injury or damage.
Explains warning symbols and general safety practices for correct unit use.
Provides essential guidelines for safe operation, installation, and maintenance.
Identifies and describes the main parts visible on the front of the unit.
Identifies and describes the main parts visible on the back and sides of the unit.
Details the control panel's layout and explains the function of each button and indicator.
Details how to adjust and the operational ranges for temperature control.
Covers choosing between Room/Spot mode, locking controls, and changing temperature units.
Explains how to operate the unit in economy mode for different models.
Provides solutions for common symptoms like unit not operating or poor cooling.
Details procedures for cleaning air filters and general unit maintenance.
Guides on selecting an installation spot and connecting water pipes correctly.
Covers post-installation checks and critical safety precautions during installation.
Lists included accessories and explains the manual pumping operation.
To Next Page
