Airstream 2012 INTERSTATE - Wheel Simulator

C - 10
C
C - 11
SPRINTER vAN
JACK
Read, understand, and follow the Sprinter operator's manual instructions, cau-
tions, and warnings for changing a wheel and jack point locations.
Warning: The jack is intended only for raising the vehicle
briefly, for instance when changing a wheel. The jack must be placed on
a firm, flat surface only. Do not change wheels on either uphill or downhill
grades. Do not crawl under the vehicle while raised with jack. Do not start
the engine while the vehicle is jacked up. Do not jack the vehicle up more
than 1.2 inches between the tire and the surface. Otherwise, the vehicle
may tip over and may cause serious injury or death to you or others. Jack
stands must always be used while working beneath the vehicle. Failure to
follow these precautions could result in property damage, personal injury
and/or death.
The jack is located together with vehicle tool kit under the hatch in the front
passenger foot well.
• Loosenthewheelnutsbeforeraisingthevehicle.
• Closethereleasevalveonthejack.
• Assemblethepumpleverprovidedandinsertitintothesocketon
the jack.
• Secureleverbyturningitclockwiseinthesocket.
• Positionthejackundertheappropriatejackpointandraisethe
vehicle by pumping the lever.
WHEEL SIMULATORS
Front Wheel Simulators
The wheel simulators are installed by Airstream.
Removing The Front Wheel Simulator: Loosen the 3 Phillips head screws until
the hook mounts disengage from the rim oval hand holes.
Installing Front Wheel Simulator
Step 1: Line up the mounting hooks on the back of the wheel simulator with
the oval hand holes of the wheel. Note: It is recommended not to use the oval
hole by the valve stem for the mounting hooks. Then gently push the wheel
simulator against the wheel until one of the hooks engage into one of the wheel
Screw
Hook