To clean the strainer screen: With the clear plastic at the top press on the sides
of the strainer releasing the tabs holding the clear plastic top in place, hold
the sides in and pull straight up on the clear plastic top to remove the screen
assembly. Rinse all debris from the screen. Replace the screen assembly by
aligning the screen in the seating groves and pressing gently down until tabs
catch and hold the clear plastic top in place.
The inlet and outlet hoses and the strainer assembly are held in place by
self sealing blue quick connect fittings. To disconnect a hose or the strainer
grasp the blue tab on the female fitting by the grooved finger edges and
pull straight out on the tab. This will release the male fitting connected to
the hoses and strainer. Be sure that both the female and male fitting on the
disconnect are free of all debris and are not damaged before replacing.
Check the pump system for leaks anytime the disconnect fittings on the
hoses and/or strainer are removed.
nOTiCE: Failure to check the quick disconnect fitting for water leaks
when reinstalling inlet and outlet hoses or the water pump strainer may
cause the pump system to leak causing damage to personal property.
To operate the system using a city water source:
CITY WATER HOOKUP
The city water inlet is a standard garden hose thread.
Use a high-pressure RV/Marine FDA approved
drinking waterhose of at least ½ “ diameter made
from material that is tasteless, odorless, and non-
toxic. We suggest you carry two lengths of hoses so
you have the ability to reach hookups further away
than normal, plus you have a spare should one fail
or become damaged unexpectedly.
After hooking up the hose and turning on the city water valve provided in the
park, slowly open a faucet. There will be spurts and sputtering until all the air is
expelled from the motorhome system. Be sure to turn the water heater bypass
to the normal flow position as described earlier in this section so it will fill. If the
water heater is empty it will take some time before all the air is expelled and
you get a steady flow of water at the faucet. Once a steady flow is achieved
Quick
Disconnect
Fitting
Blue
Finger
Ta b
City
Water
Inlet
City Water
Hookup
To Next Page
Loading...
