C - 15
C
SPRINTER vAN
The CORRECT methods are shown in Figure 1. A single tire or dual tires
are supporting the full load. Please note that the blocks are wider than the
tread and longer than the tire’s footprint. This provides maximum support to
the tires and assures that the load is evenly distributed throughout the tire’s
footprint area.
INCORRECT
INCORRECT methods are shown in figure 2: One tire, a portion of one tire, or
portions of two tires are supporting the full load.
Figure 2
Warning: Tires that are incorrectly supported may be dam-
aged which could lead to casing failure resulting in serious injury or
property damage. If, on previous occasions, the tires have been incor-
rectly supported, a hidden damage may be present. Please contact your
local tire dealer and request an inspection and a determination of possible
damage.
Auminum Wheels (Option)
Wheel Finish Care and Maintenance
1. Clean frequently with high-pressure water from a hose. The use of a mild
detergent will speed the cleaning process. Do not clean with abrasives, abra-
sive brushes, steel wool, scouring pads or strong chemicals, such as acids or
alkaline products. Never spray cold water on extremely hot wheels. Always
allow time to cool before cleaning.
2. When tires are removed, the entire wheel must be cleaned and inspected.
With a brush, remove any foreign products from the tire side of the wheel
(portion of the wheel that supports the tire). Do not use an abrasive brush to
remove dirt, corrosion or other foreign products from the wheel surfaces. It
is recommended to generously coat the entire air chamber surface with an
To Next Page
Loading...
