CAMPING
D - 21
D
not be driven if the step fails to retract completely.
The step 20 amp fuse is located in the Sprinter fuse panel under the driver’s
seat, position F-10.
Lock Extended Switch
To use the lock extend switch, turn the engine off, open the door to extend the
step, and turn the switch on. The step will now remain extended while opening
and closing the door. Turn the switch off to return step to normal operating
mode.
Warning: The lock extended switch must be turned off before
starting the engine. Failure to follow this instruction may cause property
damage or personal injury.
If you forget to turn the lock extended switch off before starting the engine, the
step will retract when the engine is started, however it will not extend when the
engine is turned off and the door is opened. To reset the step: turn the engine
off and the step lock extended switch off with the door closed.
Warning: LOOK BEFORE YOU LEAP. The step will not extend
with the opening of the sliding door when the engine is running. Check
that step is extended before leaving and entering vehicle. Failure to follow
this warning could result in person injury.
nOTiCE: Check step is retracted before moving vehicle. Failure to follow
this caution could result in property damage.
To Next Page
Loading...
