EasyManua.ls Logo

Airwell FDMX-050N-09M25 - User Manual

Airwell FDMX-050N-09M25
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
User & installation manual
IMPORTANT NOTE:
Read this manual carefully before installing or operating your new air conditioning unit. Make sure to
save this manual for future reference.
21.AW.FDMX.050-175.R32.UM+IM.EN.FR.DE.IT.SP.POR.DU.08.31.Rev01
(English- French-German-Dutch-Italiano - Português - Español - Dutch)
CEILING & FLOOR TYPE AIR CONDITIONER
F
DMX R32
Multilingual Manual
FDMX-050N-09M25 / YDAX-050H-09M25
FDMX-070N-09M25 / YDAX-070H-09M25
FDMX-100N-09M25 / YDAX-100H-09M25
FDMX-100N-09M25 / YDAX-100H-09T35
FDMX-140N-09M25 / YDAX-140H-09T35
FDMX-175N-09M25 / YDAX-175H-09T35

Questions and Answers

  • K
    Kristen RichardsonAug 11, 2025
    What to do if Airwell FDMX-050N-09M25 is not working?
    • O
      ocobbAug 11, 2025
      If your Airwell Air Conditioner isn't working, first, check for a power failure and wait for the power to be restored. Ensure that the power is turned on and the fuse isn't burned out—replace the fuse if needed. Also, check the remote control batteries and replace them if they are dead. If the unit's 3-minute protection has been activated, wait three minutes after restarting it. Finally, ensure the timer is off.
  • A
    alicestevensAug 18, 2025
    How to improve poor cooling performance of Airwell FDMX-050N-09M25 Air Conditioner?
    • A
      amberreedAug 18, 2025
      To improve the cooling performance of your Airwell Air Conditioner, start by cleaning the heat exchanger on the indoor or outdoor unit. Remove the filter and clean it according to the instructions. Ensure that the air inlet and outlet of both the indoor and outdoor units are not blocked. Turn the unit off, remove any obstructions, and then turn it back on. Make sure all doors and windows are closed while the unit is operating. Close windows and curtains to reduce excessive heat generated by sunlight. Reduce the amount of heat sources in the room, such as people, computers, and electronics. Finally, check for refrigerant leaks; if necessary, reseal and top off the refrigerant.
  • D
    Daniel PetersAug 27, 2025
    Why does my Airwell FDMX-050N-09M25 Air Conditioner start and stop frequently?
    • J
      Jennifer WoodardAug 27, 2025
      Your Airwell Air Conditioner might start and stop frequently due to several reasons. There could be too much or too little refrigerant in the system; check for leaks and recharge the system with refrigerant. Incompressible gas or moisture might have entered the system, requiring you to evacuate and recharge the system with refrigerant. A system circuit might be blocked; determine which circuit is blocked and replace the malfunctioning piece of equipment. The compressor could be broken, necessitating its replacement. Lastly, the voltage might be too high or too low; install a manostat to regulate the voltage.
  • P
    ploweSep 2, 2025
    How to improve poor heating performance of Airwell Air Conditioner?
    • J
      Jacqueline JacksonSep 2, 2025
      To improve the heating performance of your Airwell Air Conditioner, consider these points. If the outdoor temperature is extremely low, use an auxiliary heating device. Ensure that all doors and windows are closed during use to prevent cold air from entering. Also, check for refrigerant leaks; if necessary, reseal and top off the refrigerant.

Airwell FDMX-050N-09M25 Specifications

General IconGeneral
CategoryAir Conditioner
Cooling Capacity5.0 kW
Power Supply220-240V, 50Hz
RefrigerantR410A
Outdoor Unit Dimensions (WxHxD)780x540x260 mm

Related product manuals