1-1
INTRODUCTION
Revision 0
1. INTRODUCTION
1.1 General
The new FLO N split wall mounted range comprise the RC (heatpump) models, as follows:
• Cooling Only WNG 7ST, WNG 9ST, WNG 12ST, WNG 14ST,
WNG 18ST, WNG 24ST WNG 30ST
• Heat Pump FLO 7 NRC, FLO 9 NRC, FLO12 NRC, FLO 14 NRC,
FLO 18 NRC, FLO 24 NRC, FLO 30 NRC
The indoor FLO N units are available as LCD display types, featuring esthetic
design, compact dimensions, and low noise operation.
Type WNG18, WNG24, WNG30
1.2 Main Features
The FLO N series benefits from the most advanced technological innovations, namely:
• R410A models
• Microprocessor control.
• Infrared remote control with liquid crystal display.
• Supports Indoor Air Quality features, such as – Ionizer, Active Electro-Static
Filter, and Fresh Air.
• Indoor large diameter cross flow fan, allowing low noise level operation.
• Bended indoor coil with treated aluminum fins and coating for improved
efficiency.
• High COP.
• Easy access to the interconnecting tubing and wiring connections, so that
removing the front grill or casing is not necessary.
• Refrigerant pipes can be connected to the indoor unit from 6 different optional
directions.
• The FLO 18/24/30 N are equipped with a flexible corrugated copper suction
tube allowing easy bending by the installer without the necessity to use special
equipment.
• Water condensate tray is equipped with two optional drain connections.
• Automatic treated air sweep.
• Low indoor and outdoor noise levels.
• Easy installation and service.
To Next Page
Loading...
Need help?
General
