Airwheel H3TS+ - Installation and Usage; Battery Charging; Joystick Position Adjustment

- 7 -
3.Battery charging instructions
Please connect the charger to the wheelchair before connecting
it to the AC power while charging. Please align the notch on
the charger (See Picture 3-1) with the protruding part of the
charging port (See Picture 3-2), insert and tighten the xing cap
for connection. Please loosen the xing cap before removing the
charger from the wheelchair.
3-1 3-2
notch
protruding
part
4. Left and Right Joystick Exchange
4-3 4-4 4-5 4-64-1 4-2
Disconnect the joystick cable (Figure 4-1) and loosen the screw to remove the joystick (Figure 4-2). Remove notch of
one side of the joystick (Figure 4-3), turn it 180 degrees to the other armrest position, tighten the screw to secure the
joystick (Figure 4-4), then insert the joystick into the notch. Attach the screw (Figure 4-5), reconnect the joystick wiring,
and nally attach the joystick cable with the cable ties (Figure 4-6).
The joystick
groove
The joystick
assembly
Screw