Airwheel H3TS+ - Controller Operation Guide; Headrest Assembly; Headrest Installation Notes

- 13 -
7.headrest installation
Fasten the metal buckles ① and ② to the metal part ③ and ④ respectively.as the picture shows,tighten the screws,
adjust the head restraint to the proper position while tightening, and then fully tighten the screw.
1.
When installing, please pay attention to the direction of the metal
buckle,as shown in the picture, the left corresponds to the rod of the
backrest ④ ,the right corresponds to the rod of the headrest ③
2.
Part ② is above
Precautions
Adjust
the
height
of the
headrest
Adjust the
headrest
angle