Need help?Do you have a question about the Airxcel 47000 series and is the answer not in the manual?
General| Brand | Airxcel |
|---|---|
| Model | 47000 series |
| Category | Air Conditioner |
| Language | English |
Specific location advice for mounting the unit in motor homes.
Location recommendations for travel trailers and mini-homes.
Recommended placement for air conditioning units in vans.
Optimal location for truck campers to achieve maximum cooling.
Steps for preparing a roof vent opening, including sealing and resizing.
Procedures for cutting and framing a new roof opening if no vent exists.
Installing the support frame and routing power wiring.
Installation must comply with NFPA Standard 501C for safety.
Positioning the unit and pulling electrical conduit through the opening.
Placing the mount gasket and installing the ceiling assembly mount frame.
Ensuring proper bolt tension for optimal gasket compression.
Installing the drain hose for the optional condensate pump.
Guidelines for routing the 115 VAC supply wiring to the unit.
Wiring specifications based on minimum overcurrent protection device amperage.
Wiring specifications for higher overcurrent protection devices.
Uncartoning the ceiling assembly and removing grilles/filters.
Note regarding skipping a step if the heater accessory is not installed.
Fastening the duct collar to the air conditioner basepan.
Plugging the main AC electrical conduit into the ceiling assembly receptacle.
Inserting supply wiring through cable clamp and securing.
Connecting supply power conductors to pigtail wires using wire nuts.
Placing the metal control box shield over wiring and controls.
Raising and securing the ceiling assembly to the mounting frame.
Adjusting shroud for crowned ceilings or installing screws for flat ceilings.
Pulling and securing fabric duct material through the discharge opening.
Ensuring non-allergenic filters are properly positioned in the ceiling grille.
Installing the ceiling grille onto the bottom of the shroud.
Turning the selector switch to the OFF position.
Turning ON the power supply to the roof top air conditioner.
Removing ceiling assembly from carton, separating items, and removing grilles/filters.
Fastening the duct collar to the air conditioner basepan.
Raising chute, inserting wiring through cable clamp, and securing.
Connecting supply power conductors to pigtail wires using wire nuts.
Pressing supply conductors into wiring box and securing the cover.
Plugging the air conditioner electrical conduit into the receptacle.
Plugging the optional heater cord into the receptacle if installed.
Raising the ceiling assembly chute and securing it to the mounting frame.
Tying wiring to prevent contact with sharp edges or optional heater.
Pulling and securing fabric duct material through the ceiling chute opening.
Raising and securing the ceiling shroud to the mounting frame.
Installing control knobs over switch and thermostat shafts.
Re-installing the filters and grilles into the ceiling assembly shroud.
Turning the selector switch to the OFF position.
Turning ON the power supply to the roof top air conditioner.
To Next Page