●
The front-view camera is blocked;
●
The lane lines are too thin, damaged or blurred, which lead to incorrect recognition;
●
When the vehicle enters or exits a curve or a sharp bend;
●
The road width is too narrow or too wide;
●
At higher speed (50km/h above) through the small curvature curves of urban or urban diverging lanes;
●
The vehicle drives through sections without lane lines;
●
The driver actively activates the turn signal lamps to change lanes;
●
The driver activates the hazard warning lamps;
●
Put the vehicle in a gear other than forward gear;
●
The electronic stability program is activated.
●
The electronic stability program and electric power steering system,etc are faulty.
CAUTION:
●
Super cruise function is not recommended when the vehicle is driven in a very sporty style, off-road
mode or not on paved roads.
●
Severe weather conditions such as rain, snow, smoke, hail, sand, and backlight will affect the stability
of the intelligent driving mode. It is not recommended to use the SCC function in severe weather.
●
The driver's intense driving behaviors such as making a sharp turn and changing lanes and stepping on
the accelerator pedal will cause the SCC function to exit.
●
When there are complex traffic conditions around, such as merging, lane change, cut-in, cut-out,
intersection, etc., it is recommended that the driver actively take over the vehicle.
●
It is recommended to turn off the SCC function when the vehicle is passing through bad road sections
such as road construction sites; when the vehicle is driving in low visibility conditions, on steep and
winding roads and slippery roads, it is recommended that the driver actively take over the vehicle.
Enable SCC
1. When the vehicle starts and the conditions for activating SCC are met, the driver can activate the SCC
by short-pressing the intelligent driver assistance button
on the left side of the steering wheel
114 | AIWAYS
To Next Page
Loading...
