1. Insert the metal tongue of the seat belt into the corresponding buckle, draw the seat belt quickly near
the buckle and the seat belt can be fastened and locked;
2. Pull the metal tongue, quickly pull the seat belt forward and the lock mechanism should be able to lock
up automatically and prevent the seat belt from being pulled out;
3. Pull out the seat belt completely and check whether it can act smoothly and whether there is any cut,
crack, severe wear or other abnormality on your seat belt;
4. Let your seat belt roll back and check whether it can roll back smoothly and continuously, and whether
it can fully roll back;
5. Check the seat belt system to see whether it is loose or damaged and whether there is any part that
may affect the normal work of the seat belt system;
6. Check whether the seat belt OFF indicator can work properly.
If any of the above checks have not passed, please contact AIWAYS immediately for troubleshooting.
Seat belt maintenance
Use neutral soap and warm water to clean the seat belt only. Never use any solvent to wash the seat belt.
Never bleach or dye the seat belt; otherwise, the seat belt may have its strength severely weakened. After
cleaned, the seat belt shall be dried with clean cloth and kept in the shade. Before your seat belt has not
been dried completely, never let it roll back into the retractor, but keep it clean and dry. If the seat belt
retractor is contaminated with dirt, the seat belt retracting will become slow; please clean the dirt with
clean dry cloth.
Safety control
Front/rear view
Front windshield washing
Use the wiper lever switch on the right side of the steering wheel and you can set the wiper speed and
mode.
50 | AIWAYS
To Next Page
Loading...
