：When the low beams are turned on, push the light lever forward to turn on the high beams. When
the high beams are turned off, pull the lever inward and release it to use the passing light function (the
high beams light up briefly and then go out).
：Turn the knob to this position and your car will have its position lamp ON.
：Turn the knob to this position to enable the automatic headlamp mode and your car will
automatically monitor the ambient light. When the ambient light is dark, the low beams and daytime
running lamp will light up automatically; When the ambient light is bright, the light will go out
automatically.
：When the low beams are turned on, turn the fog lamp switch to this position and the rear fog
lamps will light up, and the switch will bounce back automatically; Turn down the switch once again and
the rear fog lamps will go out, and the switch will bounce back automatically.
：Turn the light switch to this position, and the light will go out.
Turn signal lamp: Move the lever downward to turn on the left turn signal lamp, and move the lever
upward to turn on the right turn signal lamp.
Headlamp height adjustment
You can adjust the headlamp height through the central control screen. The headlamp height can be
adjusted between gears 0-3.
PATH: Vehilce Settings - Lighting - Headlight
You can also adjust the headlamp height through the panoramic control interface of the central control
screen
1.
Click the lamp contact
on the model to activate the lamp adjustment.。
2. Drag the light from the model up and down to adjust the headlamp illumination height.
AIWAYS | 83
To Next Page
Loading...
