The reverse lever is fitted with a ring with which to
change the gear.
1. To apply the brake, pull the lever
as far as it will go without pushing the
button on the end of the lever.
2. To take the brake off, slightly pull
the lever, at the same time pressing
the button and lowering the lever
again.
To select a gear:
- the vehicle must be at a full standstill
- the engine must be idling
Do not park the vehicle on a slope of more than 15% and
place a wedge against a wheel if parking on a slope for a
long time.
INTERIOR REAR VIEW MIRROR
The lever on the lower part is used
to reduce glare from vehicles'
headlights behind you when driving
at night.
1. Normal
2. Anti-glare*
To move into drive or reverse gear:
- lift the ring 1
- push the lever to the required direction
- release the ring once the gear is selected 2
WING MIRRORS
Wing mirrors can be adjusted from inside with the lever button.
1. Tilt up
2. Tilt down
3. Tilt right
4. Tilt left
Never force the change into drive or reverse gear
without lifting the ring first; doing so will damage
your vehicle beyond repair.
To Next Page
Loading...
