REAR BENCH
If you wish to fold down the
rear bench of your car you
must lock the safety belts.
During handling, make sure
that they cannot get caught
or damaged.
To lift the rear bench seats, insert your hand towards the
safety belt locks, raise the seat and tip it towards the front
of the vehicle, then unlock the back of the rear bench with
the two locks located in the luggage compartment, lift it
and then place it flat behind the seat.
If you carry material in the luggage compartment, always
make sure that it cannot damage the safety belts.
SAFETY BELTS
Three-point safety belts with winders
This type of belt needs no length adjustment. Once
fastened, the belt freely adjusts to the user’s movements,
but in case of a strong or brusque jolt, it automatically
locks itself to retain the body.
Before fastening your safety belt, seat yourself well in the
back of your seat, set the seat’s advance according to the
pedals.
When you put on your safety belt, hold yourself
against the back of your seat. The thorax strap should
be as close as possible to the neck, without however
bearing on it. The basin strap should bear flat on the
thighs and against the basin.
The belt should bear most directly on the body. Avoid
very thick clothing and inserted objects …
To fasten the belt, slowly
unroll the strap and without
jolts and make sure of the
bolting in the box. Check the
efficient bolting by pulling on
the bolt. If there is locking of
the strap before the locking,
return backwards and unroll
again.
To unfasten the belt, press
the red button on the box, the
belt winds back into the reel.
Accompany the bolt to
facilitate the procedure.
To Next Page
Loading...
