REVERSING GEAR
N = Neutral point
D = Forward drive
R = Reverse drive
To select the desired gear:
1. Press the lever while advancing it. Example, to
pass from reverse drive to forward drive or to pass
from neutral point to forward drive.
2. Simply pull the lever toward the rear, to pass from
forward drive to neutral point.
3. Press on the lever and pull towards you to engage
the reverse drive.
To select a gear, it is imperative
that:
- the vehicle is completely
immobilized
- that the engine is at idle speed
NEW
The gearbox lever is equipped with a
plug to activate the gear change
To move forward or backward:
- Lift the ring
1
- Push the lever to the desired direction
- Release the ring once the gear selected
2
Never switch from drive to reverse without lifting the
ring. Failure to this procedure would result in
permanent damage to your vehicle.
To Next Page
Loading...
