AJAX FireProtect - Alarm and Test Settings; Temporary Deactivation

Alert with a siren if temperature threshold
exceeded
activated in case if temperature threshold
exceeded
Alert with a siren if rapid temperature rise
detected
If active,
added to the system
are
activated in case if rapid temperature rise
detected
Alert with a siren if CO detected (
FireProtect Plus
only
)
If active,
added to the system
are
activated in case if CO concentration is
dangerous
Jeweller Signal Strength Test
Switches the device to the signal strength test
mode
FireProtect Self Test
Starts FireProtect selftest
Temporary Deactivation
Allows the user to disconnect the device without
removing it from the system.
Two options are available:
Note that a disabled device does not trigger an
interconnected alarm of �re detectors. But if
smoke is detected, the built-in siren will sound
User Guide
Opens the detector User Guide
Unpair Device
Deletes device and its settings
sirens
sirens
Entirely
— the device will not execute system
commands or participate in automation
scenarios, and the system will ignore device
alarms and other noti�cations
Lid only
— the system will ignore only
noti�cations about the triggering of the device
tamper button
Learn more about temporary
deactivation of devices