EasyManua.ls Logo

Akai A24001 - Cleaning & Maintenance; Tips for Cleaning; Door Seals and Cavity Cleaning

Akai A24001
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
CLEANING & MAINTENANCE
The microwave should be cleaned regularly and
any food deposits removed.
Remove the power cord from the wall outlet
before cleaning. Don’t immerse the appliance in
water or other fluids when cleaning.
Failure to maintain the microwave in a clean
condition could lead to deterioration of the
surface. This could adversely affect the life of
the appliance and possibly result in a hazardous
situation.
Never use hard detergent, gasoline, abrasive
powder or metal brush to clean any part of the
appliance.
Do not remove the waveguide cover.
After lengthy use, it is possible for odors to emit
from the Microwave.
The following 3 points are some methods to
remove odors or unpleasant smells:
1. Place several lemon slices in a cup, then
heat with high Micro Power for 2-3 min.
2. Put some orange peel into the Microwave,
and then heat them with high Micro Power
for 1 minute.
Tips for cleaning
If the seal of the microwave is dirty, it may stop
the door from closing properly. Keep the seal
clean.
Spicy sauces such as ketchup and mustard,
or salty dishes such as salted meat contain
ingredients that can erode the surface. After
use, you should always clean the oven interior.
Residue of food from spillovers or splatters
will attract microwave energy causing it to
burn on. This could reduce the efficiency of the
microwave and may cause bad odours.
Details for cleaning door seals, cavity and
adjacent parts:
Exterior: Wipe the enclosure with a
dampened soft cloth
Door: Using a dampened soft cloth, wipe
clean the door and window. Wipe the
door seals and adjacent parts to remove
any spills. Wipe the control panel with a
slightly dampened soft cloth.
Interior walls: Wipe clean the cavity with
a dampened soft cloth. Wipe clean the
waveguide cover to remove any food
remnants.
Turntable / Rotation ring / Rotation axis:
Wash with mild soap water. Rinse with
clean water and allow drying thoroughly.
Note: Do not remove the Waveguide cover
during cleaning.
Make sure the Waveguide cover is installed
correctly and has not been damaged during
cooking.

Related product manuals