6
6
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Installation
• Heavy: This appliance is heavy, take care when moving it. To avoid back or other
injury, consider a two person lift or mechanical aid when installing it. Failure to do so
can result in back or other injury.
• Keep it upright: Do not tilt the fridge more than 45º from upright when moving it.
• Handle with care: Do not apply force to any part such as the condenser or door.
• WARNING: Ventilation: To ensure proper ventilation, keep any ventilation openings,
in the appliance enclosure or in the built-in structure, clear of obstructions. Ensure
adequate air circulation around the appliance to prevent overheating. Use spacers (if
supplied) to prevent warm parts (compressor, condenser) coming into contact with the
wall.
• Level: Install the appliance level in order to ensure proper operation.
• Location: Install the appliance in an area that meets the following requirements:
– Ambient temperature: The ambient temperatures must correspond to the climate
class (T) indicated on the rating plate of the appliance (16°C–43°C).
– Floor surface: The floor must be sturdy, level (or nearly level) and strong enough
to support the unit when it is fully loaded. If you must position the appliance on
carpet, use a plastic carpet protector underneath the appliance.
– Areas to avoid: Avoid areas where the appliance would be exposed to direct
sunlight, sources of heat (stove, heater, radiator, etc.), extremely cold ambient
temperatures or excessive moisture and high humidity (such as outdoors or
exposed to wind, rain water spray or drips). Installing it in the coolest area of the
room will save energy consumption and running costs.
Important Safety Instructions (Cont.)
To Next Page
Loading...