Akai AT-2650

I. TECHNICAL DATA
1. MODEL AT-2650
FM TUNER SECTION
FREQUENCY RANGE
87.5 MHz to 108 MHz
SENSITIVITY (IHF) 1.6 UV
CAPTURE RATIO 1.2 dB
SELECTIVITY (IHF) More than 80 dB
IMAGE REJECTION
More than 110 dB (98 MHz)
IF REJECTION
More than 110 dB (98 MHz)
SPURIOUS REJECTION
More than 110 dB (98 MHz)
AM SUPPRESSION 55 dB
SIGNAL TO NOISE RATIO 75 dB
HARMONIC DISTORTION MONO Less than 0.1% (100% modulation)
STEREO
Less than 0.15% (100% modulation)
FM STEREO FREQUENCY RESPONSE
20 Hz to 15 kHz +1 dB, —3 dB
MUTING
Level Control (1 #V to 100uV)/Switchable to ON-OFF
STEREO SEPARATION
More than 45 dB (1 kHz)
SUB CARRIER SUPPRESSION
More than 65 dB
OUTPUT VOLTAGE
Controllable from 0 mV to 2V (100% modulation)
ANTENNA INPUT IMPEDANCE
300 ohms balanced, 75 ohms unbalanced
AM TUNER SECTION
FREQUENCY RANGE 520 kHz to 1,605 kHz
SENSITIVITY
(IHF)
80
uV/m
(bar
antenna),
13
uV
(external
antenna)
SELECTIVITY
(IHF)
More
than
30
dB
IMAGE REJECTION
More than 80 dB (1,000 kHz) _
IF REJECTION
More than 70 dB
SIGNAL TO NOISE RATIO
More than 50 dB
OUTPUT VOLTAGE _|_ Controllable from 0 mV to 2V
ANTENNA Built-in ferrite bar antenna
MISCELLENEOUS
SEMICONDUCTORS
| Transistors: 12, Diodes: 15, FETs: 3. 1Cs: 5
POWER REQUIREMENTS
120V, 60 Hz for U.S.A. and Canada
220V, 50 Hz for Europe except UK and Australia
240V, 50 Hz for UK and Australia
110V/220V/240V. 50/60 Hz internally switchable for other
countries.
DIMENSIONS
440 (W) x 144 (H) x 368 (D) mm, (17.3 x 5.7.x 14.5”)
WEIGHT
1
1 7.5 kg (16.5 lbs)
*
For
improvement
purposes,
specifications
and
design
are
subject
to
change
without
notice.
bh