Akai AT-S55/L

V. VOLTAGE CONVERSION
REAR SIDE
POWER SUPPLY PCB
{ if
Woo
POWER TRANSFORMER
FRONT SIDE
110V AREA ° FI 400mA 250V
220V AREA : F2 200mA 250V
240V AREA | F3 200mA 250V
Fig. 4 Voltage Conversion (U/T Model Only)
Models for Canada, U.S.A., Europe, UK, and Australia
are not equipped with this facility.
Each machine is preset at the factory according to desti-
nation but some machines can be set to 110V, 220V or
240V as required.
If voltage change is necessary, this can be accomplished
as follows.
1) Disconnect AC Power Cord.
2) Loosen holding screws and remove upper cover.
3) Remove existing Line Voltage Fuse and insert
required Line Voltage Fuse in thé proper fuse
holder.