Akai CS-34 - MECHANISM ADJUSTMENTS

IV. MECHANISM ADJUSTMENTS
PAUSE LEVER
PINCH WHEEL ARM
Fig. 1
WIND PULLEY
TAKE-UP REEL TABLE
: WIND PLATE SPRING
7 SUPPLY REEL TABLE
: 0.5mm
_-7: WIND PULLEY
" RwD
REAR SIDE
“S— RWD SLIDE STOP
Fig. 4
1. PAUSE LEVER ADJUSTMENT (See Fig. 1)
Bend the part of pause lever indicated by arrow in
Fig. 1 so that at playback mode, the gap between
the pinch wheel arm and pause lever is more than
0.5 mm.
2. ADJUSTMENT OF GAP BETWEEN
TAKE-UP REEL TABLE AND TAKE-UP
WHEEL AT PAUSE MODE (See Fig. 2)
Bend the take-up lever in the direction of the arrow
in Fig.2 so that when the machine is set to pause
mode from playback mode, the take-up wheel com-
pletely separates from take-up reel table pulley and
the gap width is from 0.3 to 0.5mm.
3. F.LFWD SLIDE ADJUSTMENT (See Fig. 3)
Adjust by bending the F.FWD Slide so that when the
F.FWD and STOP buttons are gently braked simulta-
neously, the wind pulley separates from the take-up
reel table and this gap width is 0.5mm.
TAKE-UP REEL TABLE PULLEY
TAKE-UP LEVER
0.3 to 0.5mm
TAKE -UP WHEEL
PAUSE SLIDE
Fig. 2
WIND PLATE SPRING
REAR SIDE
Fig. 3
OBTAIN PARALLELISM
BETWEEN ARROW MARK
WIND SPRING
Fig. 5
4. RWD SLIDE ADJUSTMENT (See Fig. 4)
Adjust by bending the Rewind Slide so that when
the RWD and STOP Buttons are gently braked
simultaneously, the wind pulley separates from the
Supply Reel table and this gap width is 0.5mm.
NOTE: In the event that by bending the F.Fwd and
Rwd Slides a 0.5mm gap on both cannot be
attained, check the wind spring for parallel-
ism.
If it is not parallel, remove and bend wind
spring by hand to obtain parallelism. (See
Fig. 5)