Akai GX-646

V. VOLTAGE AND CYCLE CONVERSION
=
°
FUSE FI
VOLTAGE SE
fer
LECTOR
200V
AREA
250V
1.25A
I[OOV AREA 250V 2.5A
D
POWER CORD
CYCLE CHANGE SWITCH [ites
swi
_60Hz—50Hz
Fig.4 Voltage Conversion (U/T Model) and Cycle Conversion (U/T, JPN Model)
1. VOLTAGE CONVERSION (Refer to Fig. 4)
1)
2)
JPN Model (100V, 50/60 Hz)
CSA, AAL Model (120V, 60 Hz)
CEE Model (220V, 50 Hz)
UK, SAA Model (240V, 50 Hz)
Voltage can not be switched.
U/T Model (110/120/220/240V, 50/60 Hz)
Remove the back board and find out the voltage
selector and Fuse P.C Board on the upper por-
tion of the machine. Change the position of
voltage selector plugs so that the voltage to be
used coincides with the voltage shown through
the opening of voltage selector plug.
The rating of fuse (F1) differs depending on the
voltage to be used. Change the fuse according to
the specified rating shown below.
110/120 V Area 250V2.5A
220/240 V Area 250V1.25A
2. CYCLE CONVERSION (Refer to Fig. 4)
Cycle can be converted only in U/T, JPN Model.
Remove the back board and select the position of
switch located in the recess at right portion of Syscon
P.C Board to correspond to the frequency of power
to bé used. Move the switch to the right for 50 Hz
and to the left for the 60 Hz.