Akai GX-M10

xX. HEAD ADJUSTMENT
TAPE GUIDE B
CAPSTAN
PINCH ROLLER
TAPE GUIDE A HEAD HANGER
E-921
PR4-7
MIRROR
Fig. 23 Mirror Cassette Fig.24 AKAI Head Projection Gauge
1.
TAPE
GUIDE
HEIGHT
ADJUSTMENT
2.
REC/PB
HEAD
PROJECTION
(Refer to Figs. 22, 23) ADJUSTMENT
1) When using an ordinary cassette, the tape guides Set the AKAI Head Projection Gauge (Fig. 24) and
and heads, etc. are not visible. As shown in Fig. 23 adjust (a) and (b) screws (Fig. 22) so that it reads:
use a cassette tape from which part of the cassette 1.9 to 2.2-mm in the IPLS Mode, 3.55 + 0.1 mm
case has been cut out and a mirror installed for © in the Play Mode.
easy visibility of the head area when making tape NOTE: Raise or lower by exactly the same amount
guide height adjustment. the head hanger’s left and right and adjust so
2) At playback mode, using the tape guide (A) shown that the head does not lean to the left or
in Fig. 22 as standard for height, adjust tape guide _ right.
(B) height with tape guide height adjustment nut
so that the tape runs smoothly and does not catch
on the tape guides. ,
:
:
7
,
2D .