Need help?Do you have a question about the Akai GX-95 and is the answer not in the manual?
General| Track System | 4-track, 2-channel stereo |
|---|---|
| Tape Speed | 4.76 cm/s |
| Frequency Response | 20Hz to 21kHz (Metal tape) |
| Output | 0.41V (line) |
| Tape Type | type I, CrO2, Metal |
| Heads | 1 x record, 1 x playback, 1 x erase |
| Motor | 2 x reel |
| Total Harmonic Distortion | 0.8% |
| Signal to Noise Ratio | 75dB (Dolby C) |
Essential safety measures and precautions to follow during the servicing of the cassette deck.
Procedures for verifying safety standards, including leakage current and resistance tests after servicing.
Detailed explanation of the purpose and operation of each button, switch, and display on the front panel.
Step-by-step instructions for removing the upper, front, and bottom covers of the unit.
Instructions for carefully removing the cassette lid case and decorative trim parts.
Procedure for disconnecting and removing the main cassette mechanism block from the chassis.
Steps to remove the motor block from the mechanism assembly.
Detailed steps for removing the cam motor and its associated belt.
Procedure for removing the cam wheel and position potentiometer.
Guide for adjusting preset voltage levels using VR1 and VR2 on the motor PCB.
Method for measuring the pressure of the pinch rollers using a spring gauge.
Procedure for measuring the winding torque in play, fast forward, and rewind modes.
Adjusting the projection height of the record/playback head using a gauge.
Setting the correct height for tape guides to ensure smooth tape travel.
Adjusting the vertical alignment of the record/playback head for optimal output.
Aligning the azimuth of the record/playback head for accurate stereo reproduction.
To Next Page
