Need help?Do you have a question about the Akai GX-M10 and is the answer not in the manual?
General| Type | Cassette Deck |
|---|---|
| Track System | 4-track, 2-channel stereo |
| Tape Speed | 4.76 cm/s |
| Tape Type | CrO2, Metal |
| Frequency Response | 30 Hz - 16 kHz (Metal Tape) |
Procedure to change the unit's voltage setting.
Information regarding cycle conversion for the DC motor.
Explains the automatic song searching function.
Details the circuit for identifying blank tape segments.
Describes the construction of IC2, a BCD counter/decoder.
Adjusting motor leaf switch timing for smooth operation.
Setting the mute leaf switch position for correct operation.
Adjusting tape guide height for smooth tape running.
Setting the REC/PB head projection distance.
Adjusting recording/playback head height for maximum output.
Aligning head azimuth for optimal channel output.
Adjusts playback output level using a test tape.
Sets the bar meter sensitivity for recording level indication.
Adjusts the playback equalizer for optimal frequency response.
Adjusts recording peaking for maximum output.
Sets LN tape frequency response.
Sets LH tape frequency response.
Sets CrO2 tape frequency response.
Sets Metal tape frequency response.
Sets the recording level for optimal signal strength.
Confirms distortion factor across different tape types.
Adjusts the bias filter for minimum output.
Adjusts the 19 kHz filter setting.
Lists titles and identification numbers for all P.C. boards.
To Next Page
