Akai GXC-760D

CONNECTIONS
FOR
RECORDING
REGULAM
RECORDING
Connect desired program source to appropriate inputs as
shown in CONNECTIONS FOR RECORDING.
. Connect power cord and turn on Power Switch.
. Depress Eject Button and load a tape (new tape gives
best results).
. Set Index Counter to “000”.
. Set Monitor Switch to SOURCE position.
. Adjust and balance recording input level with appropri-
ate Recording Level Controls while observing VU Meters.
. When an optimum recording level has been determined,
while holding the Recording (REC) Button at depressed
position, depress PLAY ® Button to begin recording.
Automatic Stop will be effected at the end of the tape.
To stop tape during recording, depress STOP lil Button.
Connect desired source
with RCA/RCA con-
nection cord.
DOLBY RECORDING CIRCUIT
Your machine is also equipped with a Dolby Recording
Circuit and Recording Calibration Adjusters, etc. for precise
Dolby recording level adjustment according to the kind of
E
gu
tape
being
used.
Therefore,
the
following
adjustment
is
— à E necessary prior to Dolby recording.
q M e» ee): ii Dolby Recording Level Adjustment
$
1. Load a tape and set Tape Selector Switch according to
kind of tape being used.
2. Depress Tape Monitor Switch to SOURCE position.
3. Depress Cal Tone Switch and set Line Recording Level
Controls to obtain a “0” VU Meter indication on both
channels.
. Set Tape Monitor Switch to TAPE position.
. Depress Recording (REC) and PLAY ® Buttons simul-
taneously to set deck to recording mode.
. With a minus driver, adjust REC CAL Adjusters and set
meter indication to “0” VU on both channels.
Caution: Do not move Recording Level Controls. (These
controls must be left at previously adjusted
positions.)
. Release Cal Tone Switch.
. Your machine is now adjusted for Dolby Recording.
Depress Dolby NR Switch and follow regular recording
procedure through step D. Then continue as follows:
E. While holding the Recording (REC) Button at de-
pressed position, depress PLAY ® Button to begin
recording.
STEREO TAPE Once Dolby Recording Level Adjustment has been
| TA - RECORDER OR
L
STEREO AMPLIFIER
TAPE DECK carried out, re-adjustment is not necessary unless a differ-
0000 o 0o00% | RECORD PLAYER WITH ent kind of tape is used or a REC CAL Adjuster is
w———n CRYSTAL OR CERAMIC moved:
STEREO
TUNER
PICK-UP
'
TURNTABLE WITH
MAGNETIC CARTRIDGE