USB Charging :
You can plug a USB cable(not supplied) into the USB socket to charge the mobile device. Output
voltage and current is 5V/500mA. (note: All devices for USB charging are not guaranteed)
[32]
Important note – ENERGY SAVING mode :
This device is equipped with an energy saving mode: if no signal is given during 19 minutes the device
will switch automatically into standby mode in order to save energy (ERP 2 standard). Please note
that low volume setting in the audio source may be recognized as “no audio signal”: this will affect
the capability of signal detection from the device and can also originate an automatic switch into
standby mode. If this happens please reactivate the audio signal transmission or increase the
volume setting on the audio source player (MP3 player, etc.), in order to resume playback. Please
contact the local service center if the problem remains.
To Next Page
Loading...
